celeryBook a demo
Getting started

Preparing your iPad for Celery

Before you install CeleryPOS, a handful of iPad settings decide whether service runs smoothly or drops mid-order. This takes about ten minutes per device.

What you'll need
  • A supported iPad on the previous major iPadOS release, or the latest one from 30 days after Apple releases it
  • Your venue Wi-Fi name and password
  • Your Celery device login, from onboarding
  • An Apple ID signed in on the device

1. Connect to the venue network

Use the network the POS will run on every day, not a guest network: guest networks usually isolate devices, which stops the iPad reaching your printers.

Recommended Wi-Fi settings
SettingRecommended optionWhy
Auto-JoinOnThe iPad rejoins after a router restart without staff intervention.
Private Wi-Fi AddressOffA rotating address breaks the DHCP reservation that keeps the master iPad at a fixed address.
Low Data ModeOffThrottles the sync that keeps orders current.
Limit IP Address TrackingOffRoutes traffic through a relay and adds latency on the POS.
Captive-portal networks (the kind with a sign-in page) will drop the POS mid-service. Ask for a network without one.

2. Add the device in Back Office

Celery adds each iPad to your Back Office at onboarding. A recorded walkthrough for adding one yourself is on its way.

Step-by-step guide
Add a device in Back OfficeThis guide is being recorded. Until it is, our support team can walk you through it.

If something goes wrong

Almost always a captive portal or client isolation. Open Safari and load any page: if you get a sign-in screen, the network needs changing. If Safari loads normally, check the router is not isolating clients from each other.
The printer has usually been given a new address after a router restart. Print its self-test page, check the address matches the one in Back Office, and give the printer a DHCP reservation.
Low Data Mode or Limit IP Address Tracking is usually on. Both throttle the sync. Turn them off on every device on the floor.
Still stuck?Open a support ticket