celeryBook a demo
Network · 4 of 6

Connecting an iPad by Ethernet adapter

A cable is steadier than Wi-Fi, so the master iPad should be wired wherever possible. This takes about five minutes.

What you'll need
  • An Ethernet adapter that fits your iPad (USB-C or Lightning)
  • A network cable long enough to reach a switch or router port
  • Ideally, an adapter that also charges the iPad

1. Connect the adapter

Plug the adapter into the iPad, then connect the network cable from the adapter to a free switch or router port.

Choose an adapter that passes power through, so the iPad charges while it stays wired. An iPad on low battery drops off the network to save power.

2. Check the iPad is using the cable

Open Settings: an Ethernet entry appears below Wi-Fi once the cable is detected. Tap it to check the iPad has an address.

Turn Wi-Fi off on the master iPad, so it never switches to wireless and changes address when the cable is knocked.

The adapter has its own hardware address, separate from the iPad's Wi-Fi. Give the adapter a DHCP reservation, not the Wi-Fi.

If something goes wrong

The adapter is not detected. Reconnect it, try another cable, and check the light on the switch port is on.
The port may be on the guest network or another network. Ask your provider which network that port is connected to.
Still stuck?Open a support ticket